Overblog Suivre ce blog
Editer l'article Administration Créer mon blog

OBD2 Tools

OBD2 Tools

OBD2 diagnostic tools & software technical service


BMW ICOM ISTA-P Coding and Programming Questions and Answers

Publié par JTAC sur 22 Mai 2017, 18:54pm

Catégories : #bmw icom, #BMW ICOM Next, #BMW ENET cable

Here share with you some useful tips and knowledge when talking about BMW Coding and BMW Programming by ISTA Rheingold!
 
Check below Q&A: (Questions raised by a beginner and answered by a professional)
bmw-icom-ista-software
Q: Is it safe to update software with ISTA on all BMW's that come through my shop ? What problems can I run into? (assuming I have a good power supply for car and laptop)
A: Depends on many factors, but as long as you use a good ICOM and a good power supply, you should be OK.
 
Q: Can updates on comfort mode, brick an ECU (or more)?
A: As long as you stick to the proposed measures plan in Comfort Mode and your setup (laptop, software etc.) is solid, there shouldn't be any opportunity to brick an ECU.
 
Q: If updates are safe, on what series can I do them ? BMW F, G for sure..can I do E ?
A: F, G and I series and for Motorrad models with vehicle electrical system 2020 (BN2020). E Series programming is not supported in ISTA+, use ISTA/P or WinKFP for individual modules. BMW ENET Cable you may also need.
 
Q: Updates for Navi maps, can I do them in ISTA also ? Again, is it safe ? Do you recommend E-Sys more for this job ?
A: I have not attempted this with ISTA+, but would assume process is similar to ISTA/P. I'd stick with ESYS strictly for ease of use.
 
Q: I have an BMW ICOM A2+B+C with ISTA all OK. And I understand that E-Sys is more complex than ISTA, regarding coding and programming for F-Series, as NCSExpert and WINkfp are for E-Series. You can do coding in ISTA also right ? for all series ? Or ISTA does less ?
A: You need to differentiate between coding and "encoding". ISTA+ will do "encoding" depending on the programming required. That is not the same as coding (features). I don't think I'd say ESYS is more complicated than ISTA+, each are different in the way they approach coding/programming.
 
Hope this blog helps you!
 
BMW Coding and Programming related tools all here:
bmw-icom-next
BMW ICOM A2 WIFI
bmw-icom-next
BMW ENET Coding Cable
bmw-enet-cable
BMW INPA K+DCAN with FT232RQ Chip and Switch
bmw-inpa-k-dcan-cable

http://bmw-icom-a2-wifi.blogspot.com/2017/05/tips-for-bmw-icom-ista-coding-programming-faq.html

 

Archives

Nous sommes sociaux !

Articles récents