Overblog Suivre ce blog
Editer l'article Administration Créer mon blog

OBD2 Tools

OBD2 Tools

OBD2 diagnostic tools & software technical service


4 Steps to install VAS 5054A ODIS Engineering on Win8

Publié par JTAC sur 4 Février 2017, 23:30pm

Catégories : #vas 5054a, #ODIS

Tips for sharing to have ODIS-Engineering (ODIS-E) installed and run on Windows 8 operation system, to use with Bluetooth vas 5054a interface or vxdiag vcx nano 5054 diagnostic tools….. Here you go….
 
Officially, Odis Service supported for now only under Windows 7 64bit……….
The latest Odis Engineering 7.1.3 supported from latest Windows 8 or 8.1 but again for to run needs the compatibility mode!!!!!!!
 
Contents:
1 Note on installing ODIS engineering on Windows 8
2 Creation of the hardware key for license generation
3 Installing the ODIS Engineering application
4 Start the application ODIS Engineering
 
Note: vas 5054a odis source recommendation:
Obdii365.com is a man of his word to trust in
 
1 Note on installing ODIS engineering on Windows 8
ODIS Engineering is not released for operation with the operating system Windows 8. This workaround is used only for the commissioning of ODIS Engineering under Windows 8 for test purposes. Please follow the steps below to successfully run Windows 8 on your system.
 
2 Creation of the hardware key for license generation
  • Set the compatibility mode of the “HardwareInfo_de_W7.exe” file to “Windows 7”.
  • To do this, right-click on the file and select “Properties”. (See Figure 1)
select “Properties
 
  • Select the “Compatibility” tab.
  • Set “Compatibility Mode” to Windows 7 (see Figure 2)
Compatibility Mode” to Windows 7
 
  • Confirm the change with “Ok”.
 
3 Installing the ODIS Engineering application
  • After you have received the license, you can start the installation of ODIS Engineering.
  • Set the compatibility mode of the setup file to “Windows 7”.
  • To do this, right-click on the file and select “Properties”. (See Figure 3)
right-click on the file and select “Properties
 
  • Select the “Compatibility” tab.
  • Set “Compatibility Mode” to Windows 7 (see Figure 4)
Set “Compatibility Mode” to Windows 7
 
  • Confirm the change with “Ok”.
 
4 Start the application ODIS Engineering
  • After installing ODIS Engineering, you must still configure the compatibility mode of “OffboardDiagLauncher.exe”.
  • To do this, right-click on the file and select “Properties”. (See Figure 5)
select “Properties
 
  • Select the “Compatibility” tab.
  • Set “Compatibility Mode” to Windows 7 (see Figure 6)
Compatibility Mode” to Windows 7
 
  • Confirm the change with “Ok”.
Done!
Enjoy and good luck!

Commenter cet article

Archives

Nous sommes sociaux !

Articles récents