Autel IM608 BMW Mini Bar Code Remote Programming Guide

 Finally got the bar bmw/mini code remote to work with Autel IM608 (as well as IM508) so thought I would share.

To find the option to program remotes you need to go

Diagnostic > Service > Body > Central Body > Central Body Electronics

Once there you can the remote section. In the menu you have 4 options.

1 – Is to read slots

2 – Is to program slot

3 – Is to delete slot

Can’t remember what 4 is now

Start by reading slots, all blank slots will just be F’s Once you know what slot to uses, go into programming option 2

It’s asks you for the following

A 6 digit “Base Code”

A 6 digit “Random Code”

And a 16 digit “Encryption Code”

To get these numbers you need to put both code numbers together as one code. You also need to include the dash’s as digits. Once both codes are together you have a 35 digit number. Then remove certain digits to make the codes they need.

Photo’s below should explain.

But you remove the first 2 digits, then the next 6 are the base, the next 6 are the random, use the last 2 of the top number and remove the next 3, then next 14 make the last number. But also delete the last two if writing down.

Once remote coded to slot, need to sync to car.

I was doing a mini one R50 2002 and the only way I could get to work was to cycle the ignition and leave on, then just held the lock button for around 5-10 seconds and it worked.

 

 

 

 

http://www.key-programmer.org/2021/05/12/program-bmw-ews3-zke-remote-with-autel-im608/